98.4" x 3/4" (2500mm x 20mm) Haeusler 4 Roll VRM HY Hydraulic~MechanicalPlate Roll ~ Bender 1967"Delivered in (1) Piece, Ready to Load"




.jpg)
98.4" x 3/4" (2500mm x 20mm) Haeusler 4 Roll VRM-hy Hydraulic~Mechanical Plate Roll 1967
Here attached is the model # from one of the drawings, as well as the original capacity chart.
The Top and Bottom rolls diameter are at 450mm. (17 1/2")
The Entry and Exit rolls are 355mm.
So what I gather from this chart is that it will roll a 3/4” plate 2500mm wide to a minimum diameter of 21 5/8”
Or it will roll a 1 ½” plate 3’ wide to a diameter of 61”.
Both at the max pressure suggested.
The unbent flats, are twice the thickness of the plate.
Attached is a picture of the electrical DATA PLATE from the main drive motor.
The original Main Motor is 50 HP, and is rated at 415 volts at 50 Hz.
The Hydraulic Unit Motor is at 460V, because they changed this out at some point to a new Baldor motor.
They were stepping down their Canadian voltage from 575V to less than the 460V with the use of the taps on their transformer.
The TOP roll diameter is 445 mm. or 17 1/2" approximately.