FABRICATION ~ CHIP TURNING ~ CNC

TOSHIBA TMD-16 VERTICAL TURNING CENTER

SERIAL NUMBER 420089; BUILT 1995

MACHINE FEATURES AUTOMATIC TWO PALLET CHANGER (APC), FULL "C" AXIS WITH LIVE MILLING SPINDLE, 24 ATC, TWO 63" DIAMETER CHUCKS, AND FANUC 15TA CONTROL

Table diameter--63"

Maximum swing--78.8"

Maximum height top of table to bottom of ram--53"

Maximum cutting height--45.3"

Maximum cutting diameter--78.7"

Maximum load on table--11,000 lbs.

Travels--

horizontal travel of rail head; -31.7", +44.1"

vertical travel of ram; 31.7"

vertical travel of cross rail; 19.7"

Table speeds (2 ranges)--1.6 to 280 rpm

Maximum table torque--15,900 ft-lbf

Milling spindle speeds--12.5 to 1,500 rpm

Feedrates--

X-axis 472 ipm rapid/0.1 to 78.7 feed

Z-axis 315 ipm rapid/0.1 to 78.7 feed

C-axis 800 degrees per minute rapid/11.8 degrees per minute feed

Automatic tool changer capacity (ATC)--24; 8 for turning/16 for milling

Taper in ram— BT 50

Section of ram--8.66" x 8.66"

Table drive motor--60/50 HP

Milling spindle drive motor--20/14.7 HP

Power requirement--200/220 volts; 100 kVA

Equipped with;

automatic two pallet changer (APC)

24 tool capacity automatic tool changer (ATC)

turning and milling tool holders (see photo)

(8) chuck top jaws

(2) 63" diameter chucks

coolant tank and pump

Mayfran chip conveyor (recently installed)

ATC tool hoist

tool measurement presetter

Fanuc 15 TA CNC control

Condition--good; inspect under power

Weight--72,200 pounds

Floor space--313" x 288" x 220" high (rail and ram in uppermost position)