20' x 750 Ton Cincinnati Hydraulic Press Brake 1973
20' x 750 Ton Cincinnati Hydraulic Press Brake 1973
Distance between housings is 16’ 5 3/4”. Stroke length is 12”. Shut height is 10”
This Cincinnati 750 ton press brake was purchased from the original owner, it is a 1973 model.
The machine was fully operational and used every day until it was moved. No reason to assume it will not run.
When we purchased the machine the cylinders were weeping oil (which is common on these machines) and the ram had some dings and tooling marks.
There were no major leaks and not obvious operational problems.
We welded and re-machined the ram and hold bars.
We purchased new packing for the cylinders, and installed the packing.
Since we did not install the machine we assume the cylinders will weep until the packing is broken in, so assume the packing will need to be adjusted after start up.
Our guarantee is that the machine will run, contingent on being installed per Cincinnati specifications and using the proper fluids, voltages, etc.
We cannot guarantee the accuracy of the ram stroke, we tested it before removal and it was good. We assume it will need to be adjusted after installation.
Our rigger will be available for phone consultation if needed. It would be up to him if he is willing to travel to assist in installation.
The machine was fully operational and used every day until it was moved. No reason to assume it will not run.
When we purchased the machine the cylinders were weeping oil (which is common on these machines) and the ram had some dings and tooling marks.
There were no major leaks and not obvious operational problems.
We welded and re-machined the ram and hold bars.
We purchased new packing for the cylinders, and installed the packing.
Since we did not install the machine we assume the cylinders will weep until the packing is broken in, so assume the packing will need to be adjusted after start up.
Our guarantee is that the machine will run, contingent on being installed per Cincinnati specifications and using the proper fluids, voltages, etc.
We cannot guarantee the accuracy of the ram stroke, we tested it before removal and it was good. We assume it will need to be adjusted after installation.
Our rigger will be available for phone consultation if needed. It would be up to him if he is willing to travel to assist in installation.
$165,000 with the above guarantee
$130,000 as inspected
$130,000 as inspected
 Boldrini Ribo 1978.jpg)
 Schleifstein Hydraulic Flanger 1998.jpg)
 TOS Vansdorf CNC Model WRD 170 Q Floor Type Horizontal Boring Mill-1.jpg)
