39.3701" x 27.5591" x 19.6850" LK G-80 Microvector 1988/1989
Machine Description: 1988-1989 LK G80 Microvector
XYZ travel 1000mm/700mm/500mm (39.3701" X 27.5591" X 19.6850")
Renishaw PH9 Head with ruby tipped probe
P19 Probe Inerface
PHC9 MK2 - Probe Head Control Unit
TP2 Probe Extension
Machine Controller - LK2000
KAESER Compressors Air Dryer MDL-KRD10
This has a rennishaw PH9 on it and a P19 interface and has CMES for
software. It is an LK G80 machine. It has Heidenhain glass scales
which are the best you can buy. It is in great condition and has been
stored in a warehouse too.
The ph9 is in the retracted position and
still connected with about a 4-5mm probe. This machine was pampered
with service contracts and in a clean room. It has twin granite slides
and is in excellent condition for an 88-89 model machine and is actually
as accurate as the new Zeis machines that were put into this plant.
The only things that are disassembled are the slide covers and the wire way. I have all the equipment safely stored.
Purchase price new was over 200k.
This
machine has not been used for about 5 years as it was stored in the
warehouse with the intentions of an upgrade. An upgrade from Brown and
Sharpe to the latest version of pc dmis with a new interface setup etc.
has been priced to me at $17,000. The machine has a granite plate
measuring 48"x81.5"x16". The travel I am not yet sure about but they
told me it was very good because they could locate several parts on the
plate at once to check. I did not see any chips in the granite plate.
The scales were in good shape too. The machine was well taken care
of. They took it out because they wanted all machines to use the same
programming software and Zeiss would not support it if they installed
the Zeiss software on it. They tell me it is actually a more accurate
machine than the Zeiss.
$8,000.00 FOB Virginia USA
