20" Roundo R-13S Angle & Pipe Profile Bender

ROUNDO R – 13S ANGLE BENDING ROLL
Larger than Standard Diameter Shafts on Rolls (mm vs. mm)
Machine
is equipped with the Shafts, Motors, and Drives that are normally found
on the R-15S Model machine, but in the R-13S Frame
Machine Weight is approximately 120,000 Lbs.
The approximate Foot Print of the Machine is 155” x 218”, not including the Pit
Travel Speed of Materials through Machine: aprox 23ft per min
Digital Position Indicators for the (2) Rear Adjustable Rolls
Roll
Bolt & Cap Assemblies are made of (3) different height sections,
which are split halves and can be removed easily for quick adjustment of
the assembly
Beam-on-Edge Device (Hydraulically Powered), with (3) Sets of Pulling Rolls
Hydraulic Pressure Gauge in clear view during operation of device
Adjustable Guide Rolls that are Hydraulically Controlled in (3) Directions:
Up / Down; In / Out (Front to Back); and Rotating (Left / Right)
MACHINE WAS DELIVERED TO ORIGINAL OWNER IN 1996
Various Dies and Spacers including the following:
Standard Set of Angle / Bar Rolling Dies(Grooved for capture of Beam Flanges when rolling the Easy Way)
Set of Square / Rectangular Tubing Dies
Dies are Reversible, and made for both 3/8” and ½” Wall Tubing
Various
Spacer Sets used for the Rolling of Beams on Edge, Rolling Beams and
Channels the Easy Way, Spacing the Dies for Bars, Tubing, etc.