FABRICATION ~ CHIP TURNING ~ CNC

Technical Specifications:                                          HGM4008

Cutting Capacity………………………………..             8mm/3/16 SS

Cutting Length…………………………………              4000mm/157.48” 

Hold Down Cylinder…………………………..               17

Stroke Per min………………………………..                13/20

Clearance Between Column………………...                4240mm/166.93”

Table Height…………………………………..                850mm/33.46”  

Table width……………………………………                630mm/24.80”

Table Depth…………………………………..                 50mm/9.84”

Overall Length………………………………..                5370mm/211.42”

Overall Height………………………………..                 2200mm/86.61”

Overall Width…………………………………                 2950mm/116.14”

Oil Tank ………………………………………                 220 litres

Motor Power………………………………….                 30 hp

Aprox. Weight………………………………..                 29000 lb                     

Electrics…………………………………………………. 220/440 volt 3 phase.

Special Package price includes the following options:

-one metre squaring arm mounted on left side c/w inch/metric scale rule.

-2 front sheet support arms 1 metre c/w inch/metric scale rule.

-Shadow line.

-Hydraulic oil

-ELGO NC control model P9521

General Characteristics:   

      -    Welded one-piece frame using rigid structural steel.

      -    The one-piece welded frame is machined at one time on a moving column CNC

            Machining Centre and this maintains maximum cutting accuracy.

-       Special MVD INAN design that double speed operation is maintained. Slow approach for maximum accuracy.

-       Hydraulic cylinders are machined for a solid steel billet and honed afterwards.

-       Pistons are steel forged , precision ground and micro polished for years of trouble free service.

-       Hydraulic cylinders in series connection and easily serviceable.

-       World brand low-maintenance hydraulic block with pressure relief valves.

-       Side frame construction with throat allows continuous slitting of strips up to 250mm width.

-       Powerful hold down cylinders to avoid the sheet sliding during cutting.

-       Back gauge bar that swings with the top beam to prevent material from jamming.

-       Automatic swing up feature of back gauge after 1000mm to feed longer sheets through easily.

Standard Equipment ( for HGM and HAGM ):

-       Fast and powerful motorized back gauge with 1000mm length moving by ball screwed shafts.

-       Digital Burel,Elgo,Nuova position controller ( cut length, cut width, program no control ).

-       Blade gap adjustment for a good ,square, burr-free cut and for increased blade life the blade gap must be adjusted to suite blade thickness. Adjustment is made fast and simple with the single arm and its graduated markings.

-       Cutting length can be adjusted from the control panel so that the blade does not need to complete the entire cycle. This feature saves time and give greater number of strokes per minute.

-       Roller bearings on the table to help feeding sheets to the machine easily.

-       Three t-slotted front support arms with ruler and flip over stops.

-       Foot pedal control cutting operation.

-       Moveable lower blade support for accurate blade gap adjustment for the long term.

-       Finger guard through the table, side and rear guards.

-       Complete electrical switch board and control panel for 400 volt AC 3 phase and 50 Hz.

-       Oil tank level indicator.

-       Operators manual.

-       CE conformity including rear light beams.