FABRICATION ~ CHIP TURNING ~ CNC

We buy/sell/broker anything that has to do with Metal Manufacturing, Fabrication, Heavy Fabrication, Welding, and Chip Turning.
Including, but not limited to, CNC and Manual Machines, Brakes, Plate Rolls, Lathes, Boring, Press,Vertical and Horizontal Machining Centers, CNC Lathes.
Production of tanks, Dishing Press's, Spinning, Flanger & Flanging equipment for making dished end production is one of our specialties.

1 x 168 (24mm x 4267mm) CAPACITY BLUE VALLEY FLANGER #10 (SPINNING) MACHINE

1" x 168" CAPACITY BLUE VALLEY FLANGER #10 (SPINNING) MACHINE

 

DEVELOPED FOR FLANGING 2 TO 1 RATIO DISHED HEADS AS WELL AS THE STANDARD DISHED HEADS.

TANK HEAD DIAMETER........................ 84"

TANK HEAD DEEP DISH ...................... 21"

MAX KNUCKLE RADIUS ....................... 16"

FLANGING RANGE OF WORK:

IN STANDARD DISHED HEADS ................. 48" TO 14'

IN 2 to 1 RATIO DISHED HEADS ............. 48" TO 100"

50 HP Main Motor

1800 RPM

Machine Dimensions........................ 15'L X 4'W X 10'H

 25,000 Lbs.


Make - Blue Valley Machine & Mfg. Co. Inc. KANSAS CITY MO-64126. 

   

Equipped with motor drives and controls : 50 HP, 1800 RPM, with on board hydraulic pressure unit.


Centre attachment for holding dished ends from 24" to 48" .


This is an offset centering post that fits directly on the top of the standard center post.


Blanks are bolted down to the center attachment.


Rolls for the machine:

The Largest Knuckle radii is 16"


Upper flanging rolls with 90mm , 150mm , 200mm, 250mm, 300mm , 350mm & 400mm Knuckle radius.


Developed for flanging 2 to 1 Ratio Dished Heads.

Tank Head shown is an 84" Diameter with 21" Deep Dish, With 14" Knuckle Radius.

Range of work that can be flanged: 48" to 14' in standard dished heads. 

48" to 100" in 2 to 1 Ratio Dished Heads (Semi Elliptical)

Center attachment available for smaller diameters down to 24".

For most any type of dished head.

No pit is required.

A platform about 14" High will need to be built for the operator to stand on.

The center is completely motorized with limit switches for safety at each end.

The top hold down cylinder will position with the bottom center.

The adjustment for the center is by hydraulics.

This will adjust up and down as much as 26".

Push button controls for all of the electrics.

Simplified controls for the hydraulics.

By using a tracer with templates, the operation of this machine has been simplified.

The material is never pressed to the extent of making rough indentations.

Gauge thickness is automatically maintained between the large roll and the spinning roll.

The tracer minimizes operators troubles.

The basic size of the machine is 15' Long x 4' Wide x 10' High.

Total weight of approximately 25,000 Lbs..

This machine can be shipped in (1) piece either by Low Boy Trailer or Over Height, Open Top Container.

OR the unit can be dismantled into (3) pieces for export loading into closed container.

$145,000.00 USD C&F Delivered to any world port.

Thank you for contacting us. We will get back to you as soon as possible
Oops. An error occurred.
Click here to try again.